4-1
Section 4 Installation and Wiring
4-1 Installation Precautions
This section describes the precautions related to installation and wiring that must be observed in order to ensure high reliability
and performance of this system. Those calling for special attention are indicated below.
4-1-1 Installation Environment
Handle with care.
Do not install or use the product as shown below.
Doing so may cause damage, malfunction, or failure of the product.
1) Do not drop or bring down the product.
2) Do not install the unit in locations which are subject to
excessive vibration.
4) Do not install the unit in locations where there is a lot of
dust, conductive particles such as steel particles or oil
mist, or high salinity.
5) Do not use the unit in places with high temperature and
high humidity or with temperature too low.
(Locations where condensation may occur because of
rapid temperature changes.)
Operating temperature: 0 to 55°C
Operating humidity: 20 to 95%RH (without condensation)
3) Do not install the unit in locations where corrosive gas is
present.
PLC
PLC
PLC
PLC
PLC
PLC
PLC
PLC
6) Do not mount the unit on a panel in which high-voltage
devices (3000V, 6000V or higher) are mounted.
7) Do not use the same power supply which supplies the
power to a noise generating device.
+
-
8) Do not install the unit in locations where a strong electric
or magnetic field is generated.
Caution
Noise generating device
High-voltage device
To Next Page
Loading...
