Fuji Electric MICREX-SX series - 8 Ch Voltage Output Module; 8 Ch Current Output Module

2-3
Section 2 Specifications
2-2 Performance Specifications
2-2-3 8ch voltage output module
Item Specification
Type NP 1AYH8V-MR
No. of output points 8
Analogoutputrange 0to5V 1to5V 0to10V -10to10V
External load resistance Min. 500Ω Min. 500Ω Min . 1kΩ Min. 1kΩ
Max imum resolu tion 1.25 mV 1.25 mV 1.25 mV 1.25 mV
Digital input value (INT type) 0 to 16000 -8000 to 8000
Measurement accuracy Ambient temperature 18 to 28 : 0.1% (of full scale)
Ambient temperature 0 to 55 : 0.2% (of full scale) (See note 1.)
Ou t put response time Max . 2.0 ms + takt time (ms)
Max. 1.0 ms + takt time (ms) when output is disabled for channels 5 to 8
Load short-ci rcuit protection Provi ded. (See note 2.)
External connecting method Detachable terminal block: M3 screw, 20 poles
For the si gnal assignment of terminals, refer to "Section 5 Wiring".
Cable to use Be sure to use shielded twisted pai r cable.
T reatment of unused output To basically be opened
No. of occupied slots 1 (one)
No. of occupied words Input: 4 words, output: 8 words (fixed)
Note 1: For the range of 1 to 5 V, 0.3% (of full scale) when ambient temperature is 0 to 55 .
Note 2: Short-circuit protection for arbitrary one channel. The occurrence of short-circuit on multiple channels in an environment
where ambient temperature is higher than 30 may have a bad influence on internal electronic component of the
module.
2-2-4 8ch current output module
Item Specification
Type NP 1AYH8I-MR
No. of output points 8
Analog output range 0 to 20 mA 4 to 20 mA
External load resistance Max. 600Ω
Maximum resolution 2.5 μA
Digital input value (INT type) 0 to 16000
Measurement accuracy Ambient temperature 18 to 28 : 0.1% (of full scale)
Ambient temperature 0 to 55 : 0.4% (of full scale)
Ou t put response time Max . 2.0 ms + takt time (ms)
Max. 1.0 ms + takt time (ms) when output is disabled for channels 5 to 8
External connecting method Detachable terminal block: M3 screw, 20 poles
For the si gnal assignment of terminals, refer to "Section 5 Wiring".
Cable to use Be sure to use shielded twisted pair cable.
T reatment of unused output To basically be short-circuited
No. of occupied slots 1 (one)
No. of occupied words Input: 4 words, output: 8 words (fixed)