Fuji Electric MICREX-SX series - Page 38

4-6
Section 4 Software Interface
4-1 Analog Input Module
<Moving average execution times setting> (offset address +4)
Bit Flag name
Descrip tion
0(L)
Channel 1
Moving average executi on times
Moving average executi on times is indicted by a combinati on
of ON/OF F status of two bits.
1(H)
2(L)
Channel 2
Moving average executi on times
3(H)
4(L)
Channel 3
Moving average executi on times
5(H)
6(L)
Channel 4
Moving average executi on times
7(H)
8(L)
Channel 5
Moving average executi on times
9(H)
10 (L)
Channel 6
Moving average executi on times
11 (H)
12 (L)
Channel 7
Moving average executi on times
13 (H)
14 (L)
Channel 8
Moving average executi on times
15 (H)
H L
OFF OFF : Once
OFF ON : Twice
ON OFF : 4 times
ON ON : 8 times
2) When scaling parameter read mode is activated
When parameter mode is activated (module status register = 30001) and bit 1 of the parameter type setting status register is
set ON, the scaling parameter setting status of the corresponding channel is stored.
* When using D300win, assign INT type variables to these registers.
15(F) 0
+2
+3
+4 to 7
Offset value
Gain value
Unused (fixed to 0 (zero))