Fuji Electric MICREX-SX series - Page 89

App.2-3
Appendix 2 Offset/Gain Adjustment <SX-Programmer Standard>
Appendix 2-1 Offset/Gain Adjustment of Analog Input Module
4) Apply a voltage (or a current) that corresponds to the offset value to the terminal of the channel that is to be adjusted.
Set ON bit 0 (zero) of the parameter setting data register (offset address +0) to write the offset adjustment value in the
module internal EEPROM. The completion of EEPROM writing can be confirmed by that bit 0 (zero) of offset address +2 is
set ON.
EEPROM write command
5) After confirming that the data is written in the EEPROM, set OFF bit 0 (zero) of offset address +10 of the parameter type
setting register.
Completion of EEPROM writing