Fuji Electric MICREX-SX series - Module Specifications and Features

2-1
Section 2 Specifications
2-1 General Specifications
Item Specification
Physical
environmental
conditions
Operating ambient
temperature
0to+55
Storage (transportation)
temperature
-20to70
Relative humidity 20 to 95%RH, no condensation
Pollution degree 2 (no condensation)
Corrosion immunity Free from corrosive gases. Not stained with organic solvents
Corrosive gas Free from corrosive gases.
Operating altitude 2000 m or less above sea level
Transport condition: 70 kPa (equivalent to 3000 m above sea level) or more
Mechanical
service
conditions
Vi bration Half amplitude: 0.15 mm, C onstant accelerati on: 19.6 m/s
2
2 hours in each of X, Y and Z directi ons, total 6 hours
Shock Peak accelerati on: 147 m/s
2
(3 cycles in each directi on)
Electrical
service
conditions
Noise immu nity Rise time 1 ns, pu lse width 1 μs,1.5kV(noisesimulator)
Electrostatic discharge Contact discharge: 6 kV, Aerial discharge: 8 kV
Radioelectromagnetic field 10 V/m (80 MHz to 1,000 MHz)
Isolation method Between external terminal and internal logic ci rcuit:
photocoupler (signal), isolated power supply (DC/DC converter)
Between channels: Not insulated
Dielectric strength 500 V AC, 1 minute (between external wires connected together and ground)
Insulation resistance 10 MΩ or more with 500 V D C megger (between external wires connected
together and ground)
Internal cu rrent
consumption
Analog input NP1AXH8V-RM: 24 V D C, max. 200 mA (supplied from the power module)
NP 1AXH8I-RM: 24 V DC, max. 200 mA (supplied from the power module)
Analog output NP 1AYH8V-RM: 24 V DC, max. 240 mA (supplied from the power module)
NP 1AYH8I-RM: 24 V D C, max. 300 mA (supplied from the power module)
NP 1AYH4V-RM: 24 V DC, max. 200 mA (supplied from the power module)
NP 1AYH4I-RM: 24 V D C, max. 200 mA (supplied from the power module)
Analog input/output NP 1AWH6-MR: 24V D C, max. 200mA (supplied from the power module)
Installation
conditions
Structure Panel built i n type, IP30
Cooling method Natural ai r cooled
Mass Analog input NP1AXH8V-RM: approx. 240 g
NP 1AXH8I-RM: approx. 240 g
Analog output NP 1AYH8V-RM: approx. 240 g
NP 1AYH8I-RM: approx. 240 g
NP 1AYH4V-RM: approx. 240 g
NP 1AYH4I-RM: approx. 240 g
Analog input/output NP 1AWH6-MR: approx. 240g
Outside dimensions W35*H105*D111 mm (protrusion 21 mm)