Fuji Electric Monitouch V9 Series - Page 335

13-48 13. OMRON
13.2.11E5ZN
Communication Setting
Editor
Communication setting
(Underlined setting: default)
Temperature Controller
(Underlined setting: default)
*1 When writing the setting data from the V9, set “ON” for the “communication writing” setting.
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Indirect Device Memory Designation
For bit designation, an expansion code setting is required.
00H: when designating bit 0 to 15
01H: when designating bit 16 to 31
Item Setting Remarks
Connection Mode
1:1 / 1:n
/ Multi-link2 / Multi-link2 (Ethernet) /
1:n Multi-link2 (Ethernet)
Signal Level RS-232C / RS-422/485
Baud Rate 4800 / 9600 / 19200 bps
Data Length 7
/ 8 bits
Stop Bit 1 / 2
bits
Parity None / Odd / Even
Targe t Port No. 0 to 15
Item Setting Data Setting
UNIT Unit No. 0 to F (= 0 to 15)
BPS Baud rate
0: 4800
1: 9600
2: 19200
3: 38400
Communication level
LEn Data length 7
/ 8 bits
Sbit Stop bit 1 / 2
bits
Prty Parity None / Even
/ Odd
Adjustment level CMWT
Communication writing
*1
OFF / ON
4
3
2
1
0
F
E
D
C
B
A
9
8
7
6
5
Device Memory TYPE Remarks
C0 Setting area 0 00H Double-word, read only
C1 Setting area 0 01H Double-word
C3 Setting area 1 02H Double-word
15 8 7 0
n + 0 Model (91 to 98) Device type
n + 1 Address No.
n + 2 Expansion code Bit designation
n + 3 00 Station number