27
Chapter６
Setting
The following setting can be changed in any mode with an operation
panel of UPS.
No Item Default
① External Battery module(EBM) set 0set
② REPO / REMOTE Invalidity
③ UTL failure signal delay 0 second
④ Output delay 0 second
⑤ Rated Voltage 100V
⑥ Mode select Normal
⑦ Synchronized range ±3Hz
⑧ AUTOSTART after shutdown with alarm Effective
⑨ Polarity Active close
⑩ Buzzer stop No active
⑪ AUTOSTART Effective
⑫ Auto battery test Effective
⑬ Remote shut down signal term 4.5seconds
⑭ Manual Bypass Invalidity
⑮ Voltage range of HE mode ±５％
⑯ Frequency range of HE mode ±１Hz
⑰ Language Japanese
⑱ DC start Invalidity
・When the power cable is pulled out no battery, content of setting change is not
preserved.
・Only ⑥ can be changed from the network agent card by the communication.
This change becomes a compulsion change.
To Next Page
Loading...