30
It changes into the “REPO/REMOTE” display in pushing the SET button.
Push、▲ button/▼ button when you change the content display. The
content is changed when the SET button is pushed by the content that
changes and it moves to the next item display. Push the ESC button when
it returns to the “REPO/REMOTE” item.
・This setting is a function of installing in the dry contact card of the option. Do
not change the default, when the card uninstalling. The button might become
invalid, and the output might be cut.
・This terminal becomes iREMOTE ON/OFF when changing to the REMOTE
setting.
・ON button/OFF button of the panel becomes invalid when changing to the
REMOTE setting.
・Make it to the remote setting after it changes to the setting that the output is
turned off at ６-１-９ .
６-１-３ UTL failure signal delay
Figure ６-4 UTL failure signal delay
It changes into the “UTL failure signal delay” display in pushing the SET
button. Push、▲ button/▼ button when you change the content display.
The content is changed when the SET button is pushed by the content
that changes and it moves to the next item display. Push the ESC button
when it returns to the “UTL failure signal delay” item.
・This setting is a function of installing in the dry contact card of the option.
・This setting is used for the delay of the input abnormal signal (UTL failure signal)
of ９-２-６ .
CONF I GURAT I ON
UTL FALT DELAY
UTL FALT DELAY
0SECOND
UTL FALT DELAY
5SECONDS
UTL FALT DELAY
30 SECONDS
UTL FALT DELAY
120 SECONDS
Factory
Setting
〆
To Next Page
Loading...