Fuji Electric PXZ Series - Page 15

— 14 —
SEL SEL
7 sec. 3 sec.
Operating state (PV/SV indication)
To change temperature setting value (SV)
1) Press key for the position to change value. Light of corresponding position flashes.
2) Press or keys to change value.
3) The value is registered by pressing the
ENT
key.
PV
SV
SV lamp lights
PV
PV lamp lights
･ SV lamp lights, indicating
measurement value(PV)
and setting value(SV).
･ PV lamp lights, indicating
measurement value(PV).
PXZ5, 7, 9 PXZ4
The 2nd block parameters
Operating state display (one-stage display for PXZ4)
Press the key for 3 seconds to enter the 2nd block parameters.
Press the key
Press the and keys
From here on, take the same steps as above
to display the parameters listed at right.
DATA
SEL
SEL
SEL
･Indicatescontrolactioncode
･Inthisstate,thedataisset
bypressingtheand
keys.
DATA
Press the key
*Changedvalueisregisterd.
ENT
Prassthekey
*Changeofvalueisn'tregisterd
Cautions in the setting
™ After setting data, the data is automatically registered by pressing the
ENT
key.
™ If the data setting is left as it is for about 30 seconds, the display is automatically returned to the
operating state (PV/SV) display.
™ Where none of optional functions are incorporated into the unit, optional function parameters
will be skipped without appearing on the display.
Note) “ ”on the upper line is not displayed for PXZ4.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com