Fuji Electric PXZ Series - Page 53

25
Setting of control mode
[Description]
• Used to set control mode, normal/
reverse action and the direction of
burnout.
• Control mode is classified into the
standard type (1 output) and the dual
output type for heating/cooling con-
trol.
• The main body of standard type is
different from that of dual output
type. Be sure to set a code that con-
forms to the main unit.
Example) Altering lower burnout/reverse action to upper
burnout/normal action
Key operation Description
Press the SEL key for 3 seconds, and
P-n1 is displayed.
Press the or key to display
3.
Press the DATA key to display data.
Press the SV key when you need to
display the operation status display.
After pressing the ENT key, upper
burnout/normal action is registered.
Display
SEL
ENT
SV
DATA
Code
(P-n1)
Output
type
0
1
2
Single ... ...
Reverse
action
Normal
action
Dual
3
4
5
6
7
8
9
Reverse
action
Normal
action
10
11
12
13
14
15
16
17
Reverse
action
Normal
action
Reverse
action
Normal
action
18
19
Lower limit
Upper limit
Lower limit
Upper limit
Lower limit
Upper limit
Lower limit
Upper limit
Lower limit
Upper limit
Lower limit
Upper limit
Upper limit
Lower limit
Upper limit
Lower limit
Upper limit
Lower limit
Upper limit
Lower limit
Upper limit
Lower limit
Upper limit
Lower limit
Lower limit
Upper limit
Lower limit
Upper limit
Control action
Output 1 Output 2 Output 1 Output 2
Direction of burnout
Control action code table
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com