35
SV offset (Setting range: -50 to 50%FS)
[Description]
• The value set in SV offset is added
to original SV to perform control by
SV value. It is mainly used to elimi-
nate offset during P control. In this
case, designated SV value remains
unchanged.
• Control is performed by the display
SV value (SV offset is added).
Example) Set the zero shift width of 9°C to current set-
ting value.
Key operation Description
Press the SEL key for 3 seconds,
and P-n1 is displayed.
Press the SEL key repeatedly until
SVOF is displayed.
Press the or key to display
9.
Press the DATA key. Data is
displayed.
Press the SV key when you need to
display the operation status display.
After pressing the ENT key, the data
is registered.
Display
SEL
SEL
SV
DATA
ENT
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
