Fuji Electric SPH Series - Page 140

3-3
Section 3 System Denition
<Setting procedure>

Double-click “System_Denition” in the project tree. The system denition screen opens.

When creating a new project, if you use the template for the main unit to be used, the selected main unit is registered by
default as shown below.
[Insert] button
Example of using the template for
the main unit with 40 points
“Unit station No.” is automatically determined according to its connected order. (Note)

To register an Expansion unit or front board, select the main unit and then click the [Insert] button or press the <Insert> key.
The “Module insert” dialog box opens.
Notes:
The unit station No. of the front board is xed to “100” and that of the Expansion left side unit is xed to “200.”

Select the “Module group type” and then the unit to be registered (connected) from the “Outline specication” box, and then
click the [OK] button. The unit is registered as shown below. In the same manner register the other units.