Fuji Electric SPH Series - User ROM Status %MW10.298 (Read Only); SPF Original Announce Relay %MW10.299 (Read Only)

1-21
Section 1 Specications
Address Name Description
%MX10.298.0 Built-in ash memory mismatch
ON when a mismatch occurs between the contents of the RAM and
those of the built-in ash memory in the main unit.
* Transferring data from the RAM to the built-in ash memory sets this
bit to OFF.
%MX10.298.1 User ROM card mismatch
ON when a mismatch occurs between the contents of the RAM in the
main unit and those of the mounted user ROM card (ash memory).
* Transferring data from the RAM to the user ROM card sets this bit to
OFF.
%MX10.298.2
|
%MX10.298.15
Not used
Address Name Description
%MX10.299.0 Enable constant scanning ON while the constant scanning function is used.
%MX10.299.1 Enable remote RUN/STOP function ON while the remote RUN/STOP function is used.
%MX10.299.2 Enable I/O status latch function ON while the I/O status latch function is used.
%MX10.299.3
|
%MX10.299.15
Not used
(17) User ROM status %MW10.298 (Read only)
This area indicates the status of the ROM in the SPF main unit.
(18) SPF original announce relay %MW10.299 (Read only)