Fuji Electric SPH Series - Page 38

1-29
Section 1 Specications
Address Name Description Attribute
%MW1.61690
Positioning parameter current
value for CH2
Maximum frequency (1 to 200,000 Hz) [L]
R
%MW1.61691 [H]
%MW1.61692 Startup frequency (0 to 200,000 Hz) [L]
%MW1.61693 [H]
%MW1.61694 Stop speed (0 to 200,000 Hz) [L]
%MW1.61695 [H]
%MW1.61696 Acceleration time (1 to 30,000 ms) [L]
%MW1.61697 [H]
%MW1.61698 Deceleration time (1 to 30,000 ms) [L]
%MW1.61699 [H]
%MW1.61700
%MW1.61701
Not used
%MW1.61702 Creep speed (for origin return) (0 to 200,000 Hz) [L]
R
%MW1.61703 [H]
%MW1.61704 LS address (for origin return) (0 to 15) [L]
%MW1.61705 Z-phase signal address (for origin return) (0 to 15) [H]
%MW1.61706
%MW1.61707
Not used
%MW1.61708
Acceleration/deceleration time (for multi-axis control)
(1 to 30,000 ms)
[L]
R
%MW1.61709 [H]
%MW1.61710
|
%MW1.61729
Not used
%MW1.61730
Positioning parameter current
value for CH3
Maximum frequency (1 to 200,000 Hz) [L]
R
%MW1.61731 [H]
%MW1.61732 Startup frequency (0 to 200,000 Hz) [L]
%MW1.61733 [H]
%MW1.61734 Stop speed (0 to 200,000 Hz) [L]
%MW1.61735 [H]
%MW1.61736 Acceleration time (1 to 30,000 ms) [L]
%MW1.61737 [H]
%MW1.61738 Deceleration time (1 to 30,000 ms) [L]
%MW1.61739 [H]
%MW1.61740
%MW1.61741
Not used
%MW1.61742 Creep speed (for origin return) (0 to 200,000 Hz) [L]
R
%MW1.61743 [H]
%MW1.61744 LS address (for origin return) (0 to 15) [L]
%MW1.61745 Phase-Z signal address (for origin return) (0 to 15) [H]
%MW1.61746
%MW1.61747
Not used
%MW1.61748
Acceleration/deceleration time (for multi-axis control)
(1 to 30,000 ms)
[L]
R
%MW1.61749 [H]
%MW1.61750
|
%MW1.61769
Not used