Fuji Electric ZKJ Series - Name and Description of Operation Panel

5 - 1
5. DESCRIPTION OF DISPLAY AND OPERATION PANELS
This section describes the display unit and operation panel of the analyzer main unit. It also explains the
name and description of function on the operation panel.
5.1 Name and description of operation panel
(4) ESCAPE key
(8) ENTER key
(3) SPAN key
(7) DOWN key
(2) ZERO key
(6) SIDE key
(1) MODE key
(5) UP key
ENTER
In this document,
ENT indicates ENTER.
Fig. 5-1
Name 'HVFULSWLRQ Name 'HVFULSWLRQ
 02'(NH\ 8VHGWRVZLWFKWKHPRGH  83NH\ 8VHGWRFKDQJHWKHVHOHFWHGLWHP
(by moving the cursor) and to
increase numeral value.
 =(52NH\ 8VHGIRUPDQXDO]HUR
calibration.
 6,'(NH\ 8VHGWRFKDQJHWKHVHOHFWHG
item (by moving the cursor) and
numeral digit.
 63$1NH\ 8VHGIRUPDQXDOVSDQ
calibration.
 '2:1NH\ 8VHGWRFKDQJHWKHVHOHFWHGLWHP
(by moving the cursor) and to
decrease numeral value.
 (6&$3(NH\ 8VHGWRUHWXUQWRDSUHYLRXV
screen or cancel the setting
midway.
 (17(5NH\ 8VHGIRUFRQ¿UPDWLRQRI
selected items or values, and for
execution of calibration.
Push down on the key until the end.
CAUTION
Display unit
80
80
II e ev
u ~I m ___ ,,. __ e_.., -~-~=
Operation panel
• Display unit: The measurement screen and the setting items are displayed.
• Operation panel: The configuration is as shown below.
~
Cg
~ ~
~ <iJ
~
u
J