Fuji Electric ZRE-2 - Wiring

11
INZ-TN2ZRE-E
 
• Be sure to turn off the power before installing wiring. Otherwise, electric shock may result.
• Be sure to perform protective earth connection. Otherwise, electric shock or failure may
result.
• Select a proper wiring material that satises the ratings of the instrument. Otherwise, elec-
tric shock or re may result.
• Be sure to connect a power supply of correct rating. Otherwise, re may result.
• Do not use the power supply cable which does not meet the rating of analyzer.
CAUTION
The power terminal block and external input/output connector is provided at the rear panel. Refer
to the following.
Power terminal block
Digital input/output connector
(DIO 1 to 3)
External input connector (A/I)
Communication connector (RS-485)
Analog output connector (A/O)
ＩＮＬＥＴ２ ＯＵＴＬＥＴ２
ＯＵＴＬＥＴ１ＩＮＬＥＴ１
A/O
ＰＵＲＧＥ
DIO3
DIO2
DIO1
RS485
A/I
MadeinJapan
INFRARED GAS ANALYZER
E
U
F
S
250VT2AL
FUSE
PE N L
AC
POWER
V
SOURCE
SER.NO.
POWER
OUTPUT
MFD
TYPE
100VA
50/60Hz
0-10/25%
AC100V-240V
DC4-20mA
0-200/2000ppm
0-1/10%
0-200/2000ppm
ZREABV41-CGCGJ-MCGC1DE-CFYAA
NO
SO2
CO2
CO
O2
0-200/2000ppm
A9P6146T
2009-12
Electric Shock
DANGER
Please be sure to make ground (grounding) connection for safety.