Fuji Electric ZRE-2

To Next Page

To Previous Page

INZ-TN2ZRE-E

<Gas ow time> setting

(1) Press the

ENT

key in a state where the cur-

sor is placed preceding “Flow Time,” and

the ow time setting screen appears.

(2) Move the cursor to the gas you want to

change by pressing the

or the key,

and then press the

ENT

key.

(3) The highlighted value can be changed.

Change the value by pressing the

the

key, and then move the cursor to

the right by pressing the

key.

(4) After changing the value, press the

ENT

key.

(5) Press the

ESC

key to return to the auto-

matic calibration setting screen.

Note) Only the Chs used are displayed on

this screen. The Ex. time is the out-

put signal hold extension time after

the completion of calibration. It is

valid only when the hold setting is

set to “ON.” The Ex. time set here

is also the hold extension time at the

time of manual calibration.

( )

ENT

Fuji Electric ZRE-2 - Page 45