Fuji Electric ZRE-2 - Forced Run;Stop of Auto Zero Calibration

44
INZ-TN2ZRE-E

This mode is used to cancel the auto zero calibration forcedly.
(1) In the “Setting of Auto Zero Calibration”
screen that appears, point the cursor to
“Stop” by pressing the
or the key.
Press the
ENT
key.
(“Auto Zero Calibration Stop” appears
when the screen is selected while auto
zero calibration is performed.)
(2) “Stop” is highlighted, displaying a mes-
sage to conrm the stop of auto zero
calibration. Press the
ENT
key to stop the
auto zero calibration and the
ESC
key to
cancel (not stopped).
 
Auto zero calibration can be performed just once, or auto zero calibration can be forcibly stopped
during calibration.

(1) In the “Setting of Auto Zero Calibration”
screen that appears, point the cursor to
“Run” by pressing the
or the key.
Press the
ENT
key.
(2) “Run” is highlighted, displaying a mes-
sage to conrm execution of auto zero
calibration. Press the
ENT
key to execute
the calibration, and press the
ESC
key to
cancel.