EasyManua.ls Logo

Fuji Electric ZRE-2 - Page 81

Fuji Electric ZRE-2
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
74
INZ-TN2ZRE-E

 0.5L/min ± 0.2L/min
 0 to 50˚C
 10 kPa or less (Gas outlet side should
be open to the atmospheric air.)
 100 µg/Nm
3
or less in particle size of 0.3
µm or less
 Unallowable
 Below a level where saturation occurs at
room temperature (condensation unallow-
able).
Below the level where saturation occurs
at 2˚C for CO measurement in 0 to 200
ppm range, NO measurement, and SO
2
measurement.

1 ppm or less

Zero gas ; Dry N
2
Span gas ; Each sample gas having
concentration 90 to 100% of
its measuring range (recom-
mended).
In case a zirconia O
2 analyzer is installed
externally and calibration is carried out
on the same calibration gas line:
Zero gas ; Dry air or atmospheric air
Span gas ; For other than O
2 measure-
ment, each sample gas hav-
ing concentration 90 to 100%
of its measuring range
For O
2 measurement, O2
gas of 1 to 2 vol%/remains
N
2 gas

Indoor use (Select a place where the equipment does
not receive direct sunlight, draft/rain or radiation from hot
substances. If such a place cannot be found, a roof or
cover should be prepared for protection.)
Avoid a place where unit receives heavy vibration
Select a place where atmospheric air is clean

Table of Contents

Related product manuals