15 Problem Solving
580
Problem Solving
15
033-728
[Cause] The auto print formatting of the received fax document was interrupted by a manual
print operation.
[Remedy] No measure is required. The machine will automatically start the auto print job after
manual printing completes.
033-731
[Cause] The printing of the received fax document was interrupted.
[Remedy] The auto print processing of the received fax document was interrupted by a manual
print operation. No measure is required.
033-732
[Cause] An error occurred while connecting to the EP system.
[Remedy] This is an error occurring during maintenance work by Fuji Xerox. No measure is
required.
033-733
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
033-734
[Cause] Because a report job was instructed while preparing to print a received fax, the printing
of the received fax is temporarily suspended.
[Remedy] No measure is required.
033-735
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
033-736
[Cause] The forwarding job was interrupted because the data volume exceeded the upper limit.
[Remedy] No measure is required.
033-737
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
033-738
[Cause] Received abnormal JBIG data.
[Remedy] No measure is required.
033-740
[Cause] The printing of the received fax document was interrupted.
[Remedy] No measure is required.
033-741
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
033-742
[Cause] An error occurred during fax transmission. This error may occur if the remaining
capacity of the machine's memory is 10% or less and Manual Send is used.
[Remedy] If this error was caused when using Manual Send, connect the line after storing the
document, and then send. If the error still is not resolved, delete unnecessary data from
the hard disk to free up disk space, and execute the operation again.
If the error persists, contact our Customer Support Center.
033-743
033-744
033-745
033-746
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. Try again. If the error still is not resolved, contact our Customer
Support Center.
033-747
[Cause] The job is temporarily suspended.
[Remedy] No measure is required.
Error Code Cause and Remedy
To Next Page
Loading...
