Error Code
527
Problem Solving
15
017-769
[Cause] The server addresses of the POP3 server and the server certificate are not same.
[Remedy] Use the valid server certificate in which the correct server address is written.
017-770
[Cause] An error occurred in connecting to the POP3 server.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
017-771
[Cause] An error occurred.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
017-772
[Cause] The scanned documents is completely blank.
[Remedy] Take one of the following measures.
Check whether the document is blank or whether the side of the document to be
scanned is loaded correctly.
Select [Image option] in the [Advanced Settings] screen and set the scan density to
be [Darken].
If the error still is not resolved, contact our Customer Support Center.
017-780
[Cause] When [Enabled] is set to [Auto Job Promotion], a bypassed job is automatically deleted
after a certain period of time.
[Remedy] No measure is required.
Note •If necessary, change the setting by set [Disabled] or specify the period of time until a bypassed
job is deleted between 1 minute and 120 hours.
017-782
[Cause] An internal error occurred during image processing.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
017-783
[Cause] The memory became insufficient during image processing.
[Remedy] Take one of the following measures:
Transmit data with lower resolution.
Transmit data in the setting [Output Color] to [Black & White].
017-784
017-785
017-786
[Cause] An internal error occurred during image processing.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
017-787
[Cause] An error occurred while processing print data from Google Cloud Print.
[Remedy] Print by a method other than Google Cloud Print.
018-400
[Cause] Although IPsec is enabled, the IPsec settings are inconsistent.
Although [Authenticated by Preshared Key] is set in [IKE Authentication Method], a
passcode is not set.
Although [Authenticated by Digital Signature] is set in [IKE Authentication Method],
an IPsec certificate is not set.
[Remedy] Remove the inconsistency of the IPsec settings, and enable IPsec again.
When [Authenticated by Preshared Key] is set in [IKE Authentication Method], set the
passcode.
When [Authenticated by Digital Signature] is set in [IKE Authentication Method], set
an IPsec certificate.
018-405
[Cause] An error occurred during LDAP authentication.
[Remedy] The account is disabled in the active directory of the authentication server, or the access
is set to disabled. Consult your network administrator.
Error Code Cause and Remedy
To Next Page
Loading...
