3 Copy
170
Copy
3
Finisher-B1
Bond, Plain, Recycled, Plain Reload, Lightweight, Heavyweight, Heavyweight Reload,
Extra Heavyweight, Extra Heavyweight Reload, Punched, Gloss, Gloss Reload,
Heavyweight Gloss, Heavyweight Gloss Reload, and Custom Paper 1 to 5.
C3 Finisher/C3 Finisher with Booklet Maker
Bond, Plain, Recycled, Plain Reload, Lightweight, Heavyweight, Heavyweight Reload,
Extra Heavyweight, Extra Heavyweight Reload, Punched, Gloss, Gloss Reload,
Heavyweight Gloss, Heavyweight Gloss Reload, and Custom Paper 1 to 5.
Important • Ensure that the actual orientation of the original document matches the [Original Orientation]
setting on the [Layout Adjustment] screen.
In the following cases, the actual stapling position differs from the stapling position displayed on the
screen:
- When [Original Orientation] is set to [Upright Images], and [Staple] is set to one position at the
right side.
- When [Original Orientation] is set to [Sideways Images], and [Staple] is set to one position at the
left side.
Hole Punch
Sets the position for punching.
The positions for punching vary depending on a finisher installed.
The C3 Finisher and C3 Finisher with Booklet Maker offer nine different punch positions: 2
Holes, 2 Holes Top, 2 Holes Right, 3 Holes, 3Holes Top, 3Holes Right, 4 Holes, 4 Holes Top, 4
Holes Right.
Important • Ensure that the actual orientation of the original document matches the [Original Orientation]
setting on the [Layout Adjustment] screen.
Original Orientation
Allows you to specify the orientation of the document so that the machine can identify the
top of the document.
Note • If the [Original Orientation] setting differs from the actual document orientation, the machine may
not detect the top of the document correctly.
Upright Images
Select this option when placing the top edge of the document against the top side of the
document glass or document feeder.
Sideways Images
Select this option when placing the top edge of the document against the left side of the
document glass or document feeder. Always select [Sideways Images] when the top of
the document is placed facing the left side (horizontal text).
Z Fold Half Sheet
The machine folds the output copies in Z fold. Z fold can be applied to B4, A3, 11 x 17". If
you have mixed sized documents, the width (vertical direction) of the paper must be the
same, such as a combination of A4 (portrait) and A3 (landscape), and a combination of B5
(portrait) and B4 (landscape). When you have the combinations, the Z fold is only applied
to the larger papers (A3(landscape) and B4 (landscape)).
Output/Offset
Allows you to select the output destination tray and offset operation.
Offset Stacking
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
To Next Page
Loading...
Need help?
General
