7 Advanced Settings
154
[Login Password]
Enter the login password with up to 128 characters.
[Server Certificate Verification]
Select whether or not to verify a server certificate when [PEAP / MS-CHAPv2] is selected
in [Authentication Method].
[Certificate Revocation Settings]
Configure the settings for certificate revocation retrieval.
[Level of Certificate Verification]
Select a level of certificate verification.
Selecting [Low] does not verify the validity of certificates.
Selecting [Medium] verifies the validity of certificates. If a certificate cannot be verified
because of a network error or any other problems, the certificate is determined as valid.
Selecting [High] verifies the validity of certificates, and determines only certificates that
have not been revoked as valid.
[Retrieval of Certificate Status]
Select the method to verify the validity of certificates.
Select [By Retrieving CRL] if the device retrieves a CRL (Certificate Revocation List) from the
validation authority to verify the revocation status of the certificate. Select [By OCSP] if the
device uses OCSP (Online Certificate Status Protocol), which can verify the validity
revocation status of the certificate, to have the certificate authority or validation authority
check the revocation status.
[Auto Retrieval of CRL]
Select whether or not to automatically retrieve a CRL.
[CRL Retrieval Timeout]
Specify a time-out value to retrieve a CRL.
[Query to OCSP Responder]
Set how to access an OCSP responder.
You can select from [Use URL in Certificate] or [Use URL by Administrator].
[URL of OCSP Responder]
Enter the URL of an OCSP responder when [Use URL by Administrator] has been selected
for [Query to OCSP Responder].
[OCSP Communication Timeout]
Specify a time-out value for OCSP communication from 5 to 60 seconds in 1 second
increments.
To Next Page
Loading...
Need help?
General
