Configuration of Scan to FTP/SMB
105
Using Scan Service
11
6) Select [Save].
7) Configure [TCP/IP - Subnet Mask] and [TCP/IP - Gateway Address] as the above.
Note • Enter address in the format "xxx.xxx.xxx.xxx". xxx should be a numeric value in the range
from 0 to 255. However, the first xxx cannot be 127 or any value between 224-255.
• Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252,
254 and 255. However, you cannot use 0 between non-zero values.
• If you do not wish to set the gateway address, enter "0.0.0.0".
5 Select [Close] repeatedly until the [System Settings] screen is displayed.
6 Select [Exit].
7 After the machine is restarted, print out a settings list to confirm that either the SMP
port or FTP client port is enabled and the IP address is configured.
For information about how to print a settings list, refer to [Print Report/List] in Chapter 12, [Machine
Status], of the User Guide.
Configuration on Computer
The following describes the configuration procedure for your computer.
â– Using with FTP
Create a folder for transmission destinations to the server which log in.
â– Using with SMB
Create a folder on the computer and configure it as shared folder.
To Next Page
Loading...
