Network Setting Items (Port/Protocol) for CentreWare Internet Services
63
Using CentreWare Internet Services
9
SMB
This section describes the settings for SMB.
1 Start a web browser.
2 Enter the machine’s IP address or the Internet address to the address entry column
on the browser, and press the <Enter> key.
z
Example of the IP address entry
http://192.168.1.1/
z
Example of the Internet address entry
http://myhost.example.com/
Note • When specifying a port number, add ":" and a port number to the end of the Internet
address.
3 Click the [Properties] tab.
4 Click [+] on the left of [Protocol Settings] to display the items in the folder.
5 Click [SMB].
6 Set the [Workgroup Name].
7 Set the [Host Name].
8 Set the [Maximum Session].
9 Select the [Enable] check box to enable the [TBCP Filter].
10 Select the [Enable] check box to enable [Unicode Support].
11 Select the [On] check box when using [Automatic Master Mode].
12 Select the [On] check box when using [Encryption Password].
13 Reflect the values as the machine's setting values.
1) Click the [Apply New Settings]. A screen to enter the user name and password will
be displayed.
2) Enter the System Administrator UserID and password into [User Name] and
[Password], and then click [OK].
Note • The default User ID value is "11111" and password is "x-admin".
3) The right frame on the web browser will change to the machine reboot display.
4) Click [Reboot]. The machine will reboot and the setting value will be reflected.
To Next Page
Loading...
