9 Using CentreWare Internet Services
64
Using CentreWare Internet Services
9
NetWare
This section describes the settings for NetWare.
1 Start a web browser.
2 Enter the machine’s IP address or the Internet address to the address entry column
on the browser, and press the <Enter> key.
z
Example of the IP address entry
http://192.168.1.1/
z
Example of the Internet address entry
http://myhost.example.com/
Note • When specifying a port number, add ":" and a port number to the end of the Internet
address.
3 Click the [Properties] tab.
4 Click [+] on the left of [Protocol Settings] to display the items in the folder.
5 Click [NetWare].
6 Set the [Host Name].
7 Select an operation mode from the [Active Mode] pull-down menu.
8 Set the [File Server Name].
Note • Set this item only when the operation mode is in Bindery Service.
9 Set the [Poling Interval].
10 Set the [Number of Searches].
11 Set the [Password].
1) Enter the [Password].
2) Re-enter the same password in the [Confirm Password].
12 Select the [Enable] check box to enable the [TBCP Filter].
13 Set the [Tree Name].
14 Set the [Context Name].
Note • Set this item only when the operation mode is in Directory Service.
15 Select a frame type from the [Transport Protocol - Frame Type] pull-down menu.
Note • Set this item only when the operation mode is in Directory Service.
To Next Page
Loading...
