Fuji Xerox DocuCentre-IV C4475 Administration Guide

15 Problem Solving
454
Problem Solving
15
Part of the image
is missing on the
copy.
The paper is damp. If the paper is damp, the copy image may be
partially missing or unclear. Replace the
paper with new one.
Refer to "Loading Paper" (P.50).
Folded or wrinkled paper is
included in the tray.
Remove the unsuitable paper or replace all of
the paper with new one.
Refer to "Loading Paper" (P.50).
The document is pasted or
folded.
The pasted or folded section may not be
laying flat on the document glass. Place a
stack of white sheets on top of the document
to flatten the document against the
document glass.
The copy has a
stripe pattern.
The document enlargement
ratio is too large.
Vertical stripes may be printed on the copies
depending on the ratio. Adjust the ratio to
eliminate the stripes.
Refer to "3 Copy" > "Copy" > "Reduce/Enlarge (Making
Enlarged/Reduced Copies)" in the User Guide.
The copy is
misaligned or
skewed.
The document is not loaded
correctly.
Load the document correctly.
Refer to "3 Copy" > "Copying Procedure" in the User
Guide.
The document guides on the
document feeder are not set
in the correct positions.
Load the document correctly, and align the
document guides to the document.
Refer to "3 Copy" > "Copying Procedure" in the User
Guide.
The paper tray is not inserted
correctly.
Firmly push in the tray until it stops to set it
properly.
Refer to "Loading Paper" (P.50).
The paper guides in Tray 5
are not set in the correct
positions.
Load the document correctly, and align the
paper guides to the document edges.
Refer to "Loading Paper in Tray 5" (P.52).
Symptom Cause Remedy

Fuji Xerox DocuCentre-IV C4475 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV C4475
Category	All in One Printer
Language	English