Fuji Xerox DocuCentre-IV C4475 Administration Guide

15 Problem Solving
492
Problem Solving
15
012-259
012-260
012-261
012-263
012-264
012-265
012-266
012-268
012-269
012-280
012-282
012-283
012-284
012-286
012-287
012-291
012-295
012-296
[Cause] Finisher malfunction
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
012-334
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
012-402
[Cause] The hole punch waste container of the finisher is not installed.
[Remedy] Install the hole punch waste container. When the same message is displayed even after
you install the hole punch waste container, remove the container, and then install it
again.
012-500
[Cause] An error occurred in the finisher.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
013-210
013-211
013-212
013-213
013-220
[Cause] An error occurred in the Booklet Unit.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
016-210
016-211
016-212
016-213
016-214
016-215
016-216
016-217
016-218
016-219
[Cause] An error occurred in the software.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
Error Code Cause and Remedy

Fuji Xerox DocuCentre-IV C4475 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV C4475
Category	All in One Printer
Language	English