Error Code
569
Problem Solving
15
133-710
[Cause] When printing the received fax document, the paper loaded on the bypass tray was
used for printing because the specified tray could not be used.
[Remedy] Take one of the following measures:
z
Load paper available for printing the received fax document:
A3 SEF , A4 LEF , B4 SEF , B5 LEF ,
A4 SEF , A5 SEF , B5 SEF , 8.5 x 11" SEF ,
8.5 x 13" SEF , 8.5 x 14" SEF , 11 x 17" SEF ,
8.5 x 11" LEF , 5.5 x 8.5" SEF .
z
Use a paper type available for printing the received fax document:
plain paper, bond paper, recycled paper, side 2 paper, user-defined custom paper.
z
Confirm the settings by selecting [Tools] > [Fax Service Settings] > [Fax Control] >
[Receiving Paper Size].
1)Select [Receiving Paper Size] > [Tray Mode] to add a tray to be used for printing the
received fax documents.
2)Set up paper so that the tray specified for [Tray Mode] can be used for printing the
received fax documents.
If the error still is not resolved, contact our Customer Support Center.
Error Code Cause and Remedy
To Next Page
Loading...
Need help?
General
