6 – 105
Chapter 6 General
Tray1 Feed SOLENOID (Half/Initial
Position Rotation)
1) Power on the printer, and enter the Diag Mode.
2) Open the Tray 1.
3) Execute the Tray1 Feed SOLENOID (Half or Init).
4) Check that the Feed Roll rotates.
5) Press the "STOP" key to stop the test.
6) Replace the Tray 1.
Exit Motor (FULL1/ FULL2/ FULL3
/HALF)
1) Power on the printer, and enter the Diag Mode.
2) Execute the Exit Motor (FULL1,FULL2,FULL3 or HALF).
3) Check that the Exit Roll rotates.
4) Press the "STOP" key to stop the test.
Motor/Clutch/Solenoid Name
(Diag. Code)
Check procedure
MiA02018GA
Feed Roll
Exit Roll
MiA02019GA
To Next Page
Loading...
