3-66 Phaser 5500 Printer Service Manual
Jam at Tray 5 (Feed Out Sensor #5) Troubleshooting Reference
Applicable Parts References
■ Feed Roller
■ Retard Roller
■ Nudger Roller
■ Engine Logic Board
■ Tray 4-5 PWB
■ Tray 5 Pre-Feed
Sensor
■ Feed Out Sensor #5
■ Print Engine P/J Engine Logic Board (page 10-13)
■ PL8.1 Print Engine Electrical (page 9-40)
■ Phaser 5500 Printer Options Service Manual
■ 1000-Sheet Feeder P/J Locator (page 5-5)
■ 1000-Sheet Tray 4 & 5 Wiring (page 5-9)
■ PL20.4 Tray 4-5 Feeder (2/2) (page 4-10)
■ PL20.6 Tray 4-5 Drive and Electrical (page 4-16)
Jam at Tray 5 (Feed Out Sensor #5) Troubleshooting Procedure
Step Actions and Questions Yes No
1
Check paper condition.
Is the paper in the tray damaged?
Replace the
paper.
Go to Step 2.
2
Check paper size settings.
Does the paper size match the setting?
Go to Step 3. Correct paper
size settings.
3
Remove the tray and check the rollers.
Is the Feed, Retard, or Nudger Roller
worn or contaminated with paper dust?
Clean or replace
the Rollers.
Go to Step 4.
4
Check paper position at Door C.
Does the paper touch the Tray 5 Pre-
Feed or Feed Out Sensor #5?
Remove the
paper.
Go to Step 5.
5
Test the Tray 5 Pre-Feed Sensor.
1. Open Door C.
2. Run the Service Diagnostics Tray 5
Pre-Feed Sensor test.
Does the sensor change state?
Go to Step 12. Go to Step 6.
6
Check the Tray 5 Pre-Feed Sensor
connection.
Are P/J103A, P/J661A and P/J549A
connected?
Go to Step 7. Connect the
sensor.
7
Check continuity between the Tray 5 Pre-
Feed Sensor and Tray 4-5 PWB.
Is there continuity on each wire
between P/J103A <=> P/J549A?
Go to Step 8. Repair the wiring.
8
Check for +5 V at Tray 5 Pre-Feed Sensor
Is there +5 V across the sensor
connector’s Pin 1 <=> ground?
Replace the
sensor.
Go to Step 9
9
Check connections between the Tray 4-5
PWB and Engine Logic Board.
Are P/J541 and P/J413 connected?
Go to Step 10. Connect P/J541
and P/J413.
To Next Page
Loading...
