FujiFilm FinePix F11 - Page 21

41
Advanced Features
3
40
<
Aperture priority AE
MM
APERTURE PRIORITY AEAP E RT U R E P R I OR I T Y A E
0
OFFOF F
OFFOF F
AUTOAU TO
1
2
:
M
:
:
:
:
:
S
A
1
This is an automatic mode to set the aperture.
Use this mode to have the area in front of and
behind the subject out of focus (large aperture) or
have both near and far subjects in focus (small
aperture).
1Select “<” APERTURE PRIORITY AE (➡P.38).
2Press the “MENU/OK” button to confirm your
selection.
A
SETTING APERTURE SE T TI NG AP ER TU RE
320320320 F4.5F4.5F4.5
NNN
101010
ISOIS O 200
2
Press the “Ñ (b )” button to select SETTING
APERTURE.
◆
Shutter speed
◆
When shooting a moving subject, you can either “freeze the motion” or “capture the sense of
movement” by adjusting the shutter speed.
Freezes the motion of
the subject.
Photographs the traces
left by the subject’s
movement.
Fast Slow
Continued
SELECTING PHOTOGRAPHY MODE
PHOTOGRAPHY MENU
3
Press “d” or “c” to select the shutter speed.
h Shutter speed setting
3 sec. to 1/1000 sec. in 1/3 EV increments
When the correct exposure cannot be obtained with
selected shutter speed, the aperture setting appears
in red. When this occurs, adjust the shutter speed
again.
500500 F4F4F4
NNN
101010
ISOIS O 200
SELECTSE L EC T SETSE T
10001000 F2.8F2.8F2.8
NNN
101010
ISOIS O 200
SELECTSE L EC T SETSE T
F2.8F2.8F2.8
Lit redLit red
When the brightness of the subject is outside the
camera’s brightness metering range, “F---” appears
as the aperture setting. When this occurs, press the
shutter button down halfway to measure the light
level again.
505050 F---F---F---
NNN
101010
ISOIS O 200
SELECTSE L EC T SETSE T
●
! Macro and Flash mode cannot be selected during adjusting
shutter speed. To select these modes, press the “
Ñ(b)”
button.
●
! [500] in the bottom-left corner of LCD monitor is shown that
the shutter speed is 1/500 second. When the shutter speed is
3 seconds, [3”] appears on the LCD monitor.
Press the shutter button to take pictures.
Click
4
Shutter speedShutter speed
0!
0@