FujiFilm FinePix F11 - Ï FORMAT; Ó TIME DIFFERENCE

93
Settings
4
92
Press “c”.
3
LOCATION:LO C AT IO N :
TIME DIFFERENCETI M E DI F FE RE N CE
TIME DIFFERENCETI M E DI F FE RE N CE
TIME DIFFERENCETI M E DI F FE RE N CE SETS ET
SET CANCELS ET C AN C E L
6
When the Photography mode is selected with world
time set, “ß” appears on the LCD monitor for 3
seconds and the date turns yellow.
NNN
101010
10/24/2005 11 : 00 AM1 0 /24 / 2 0 0 5 1 1 : 0 0 AM10/24/2005 11 : 00 AM
Upon returning from a trip, always change the
World time setting back to “
å” HOME.
5
Always press the “MENU/OK” button after the
settings are completed.
TIMEIM E DIDI FFERENCEFF E RE NC E
00 00
SETSE T CANCELC AN CE L
10/24/2005 10:00AM
10/24/2005 10:00AM
1Press “d” or “c” to select +/–, hour and minute.
2Press “a” or “b” to correct the setting.
h Available time setting
–23:45 to +23:45 (in 15-minute increments)
01 02
4
LOCATION:LO C AT IO N:
TIME DIFFERENCETI M E DI F FE RE N CE
TIME DIFFERENCETI M E DI F FE RE N CE
TIME DIFFERENCETI M E DI F FE RE N CE SETS ET
SET CANCELS ET C AN C E L
1Press “d”.
2Press “a” or “b” to select “TIME DIFFERENCE”.
01 02
2
ó
TIME DIFFERENCE
This function sets a time difference relative to the date and time currently set. When this setting is
enabled, the specified time difference is applied when pictures are taken.
Use this function when traveling to destinations in different time zones.
1
1Press “c”.
2Press “a” or “b” to change between “å” HOME
and “ß” LOCAL.
To set the time difference, select “ß” LOCAL.
å HOME: Your home time zone
ß LOCAL: Your destination time zone
SET SE T CANCEL CA N CE L
LOCATIONLO CATI ON
TIME DIFFERENCETI M E DI F FE RE N CE
HOMEHO ME
TIME DIFFERENCETI M E DI F FE RE N CE
:
01 02
ï
FORMAT
Initialize (format) the xD-Picture Card for use with
the camera.
Because initializing the xD-Picture Card erases all
the frames (files), including protected frames (files).
Back up important frames (files) onto your PC or
another media.
1Press “d” or “c” to select “OK”.
2Pressing the “MENU/OK” button erases all the
frames (files) and initializes the xD-Picture
Card.
●
! When [CARD ERROR], [WRITE ERROR], [READ ERROR]
or [CARD NOT INITIALIZED] appears, see P.116 for
information before formatting the xD-Picture Card.
01 02
FOF OR MATMAT OK?O K ?
FORMATFO R MAT
SETSE T
OKO K
ERASER A SE E ALA L L L DATAD ATA
CANCELCA N CE L
SET-UP
✽ How to use the SET-UP menu (➡P.86) ✽ How to use the SET-UP menu (➡P.86)