13
Getting Ready
1
12
1
1Check that the camera is turned off.
2Plug the terminal adapter into the terminal
adapter connection socket on the camera.
2
Plug the AC power adapter connector into the “DC
IN 5V” socket of the terminal adapter.
3
Plug the AC power adapter into the power outlet.
CHARGING THE BATTERY
4
Close the battery cover.
LOADING THE BATTERY AND THE MEDIA
◆
How to replace the xD-Picture Card
◆
Push the xD-Picture Card into the slot and then
slowly remove your finger. The lock is released and
the xD-Picture Card is pushed out.
Checking the battery charge
1There is ample battery charge.
2The battery is almost half charged.
3There is insufficient charge left in the battery.
The battery will soon run out. Have a new
battery ready.
4The battery is depleted. The display will shortly
go blank and the camera will stop working.
Replace or recharge the battery.
Blinking red
Lit white
Lit white
1
2
4
Lit red
3
Turn the camera on and check the battery level indicator on the LCD monitor.
●
!
Battery with no remaining charge (V blinking red) may
cause camera faults such as the camera turning itself off
without retracting the lens. Always load a new or fully
charged battery.
“Z”, “E” or “Ô appears as a small icon on
the left-hand side of the LCD monitor.
●
!
Depending on the camera mode, the transition from “Ô to
“
V” may occur more quickly.
●
!
Due to the nature of the battery, the battery level indicator
(
E, Ã or V) may appear early when the camera is
used in cold locations. This is normal. Try warming the
battery in your pocket or a similar location before use.
“V” appears as a large icon in the center of the
LCD monitor.
◆
Auto power off function
◆
When the Auto power off function is active, if the camera is left unused for 2 or 5 minutes, this function
turns the camera off (➡P.91). To turn the camera back on, press the “POWER” button. To play back
images, hold down the “
w” button for about 1 second.
Make sure that battery
does not fall out when
replacing it.
Continued
To Next Page
Loading...
