30
11
Releasing the Shutter
■ Check that the focus indicator “●” is lit and then slowly press the
shutter button down fully to release the shutter.
1
Press the shutter button halfway and check the
viewfinder display.
• If the flash recommended icon “j” is flashing in the viewfinder display,
use the built-in flash (☞ P.74, 76).
• If a warning is displayed on the top display panel or viewfinder display,
refer to P.121 and P.122 for information on how to respond.
2
Check that the focus indicator “
●
” is lit and then gently
press the shutter button fully.
• The “REC” icon flashes on the rear display panel while the image is
being recorded.
• The shutter does not release during recording when Preview mode is set
to ON.
• If the number of prints display is highlighted, the shutter will not release
even when the focus indicator “●” is lit.
• When there is no media loaded, you can display and review an image
but you can not record it.
To Next Page
Loading...
