Fujitsu Airstage J-II - Page 626

COMPLETION OF FUNCTION SETTING MODE

(13) Press and hold the “MANUAL/AUTO ”
button for 3 seconds.
Pi Pi Pi
MANUAL
AUTO
MANUAL AUTO
IR RECEIVER UNIT
Each LED light brightness is darkening though the content
¾
of the display doesn't change.
(14) Press the “RESET” button.
After pressing the RESET
button, please set the custom
code again if b,c,d setting.
The function setting signal is not received after switched function setting completion mode. (Pi Pi Pi Pi Pi)
¾
Press the "MANUAL/AUTO
¾
" button again for 3 sec to return to if required to return the function setting
mode.
RECONFIRMATION OF FUNCTION SETTING

(15) Press and hold the “FAN” and the “ SET
TEMP.
p
” buttons. Whilst holding these 2
buttons, press the "RESET" button.
SET TEMP. ( )
RESET
FAN
Function setting
mode display
¾
(16) Function number to be conrmed is displayed.
Refer to (7).
Press the “TIMER set (-)” button.
"TIMER set (-)"
Case1 : When setting number is one digit. Case2 : When setting number is two digits.
(Example) Function number : 26, Setting number : 31
OPERATION LAMP
(GREEN)
TIMER LAMP
(ORANGE)
FILTER LAMP
(RED)
0.5sec ON / 0.5sec OFF
0.5sec ON / 0.5sec OFF
OFF
OFF
1 time
3 times
2 times
6 times
...
...
...
(Phase1) : 12sec (Phase2) : 12sec
0.5sec ON / 0.5sec OFF 0.5sec ON / 0.5sec OFF
(Example) Function number : 30, Setting number : 01
OPERATION LAMP
(GREEN)
TIMER LAMP
(ORANGE)
FILTER LAMP
(RED)
0.5sec ON / 0.5sec OFF
OFF
1 time 1 time
3 times 3 times
...
...
(Phase1) : 12sec (Phase1) : 12sec
0.5sec ON / 0.5sec OFF
RESET
- (07-100) -
FUNCTION SETTING FUNCTION SETTING