Fujitsu AIRSTAGE J-IIIL - Page 611

00 01 0200 00 000 0 0 03 04 0500 00 000 0 0
*1
2 wire type R.C.
R.C.line: 2 wire
2 wire type R.C.
00
*
1
: Set the remote controller address “0” only.
Address is automatically assigned from Remote controller.
• RB unit branch merging (
UTP-RX08AH, UTP-RX12AH)
– PC board layout
DIP switch SET2
REF AD×10 REF AD×1 RB AD×10
RB AD×1
Rotary switch
• Touch panel controller setting (Set G)
Before performing the initial setting, set the Touch panel controller address first. For details,
refer to the setting manual.
00 01 02 03
Touch panel controller (Max. 16) *
2
*: The sum total of the Touch panel controller, Central remote controller, Network convertor for
Group remote controller
, Modbus convertor, and Network convertor for LonWorks is a maxi-
mum of 16.
1-3. Manual address setting method - (07-11) - 1. System settings
FUNCTION SETTINGS FUNCTION SETTINGS