Indoor unit address setting
1. In the function setting mode display, press the MODE button to enter the address setting mode.
2. Make sure that the function number displayed on the remote controller LCD is “01”. If the num-
ber is other than “01”, press the
SET TEMP.
or button to change the number.
3. Press the FAN button to enter the address data setting mode. The address data will flash when
this button is pressed.
4. Press the SET TEMP. or button to adjust the address data. The indoor unit address range
is between “00” and “63”.
Each time the MODE button is pressed, it switches between the left digit and the right digit.
Change digit
Range
00 to 63
: Up
: Down
1-4. Address setting by remote controller - (07-19) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
