Completion of address setting mode
• The position of the MANUAL AUTO button varies depending on the model. For the actual position
of the button on each unit, refer to the operation manual.
• If the MANUAL AUTO button is pressed continuously for 10 seconds or more, the error will be dis-
played. In this case, release the button or turn off the power.
1. Press and hold the MANUAL AUTO button for 3 seconds. The brightness of each LED lamp is
darkening though the content of the display does not change.
3 short beeps
MANUAL
AUTO
MANUAL AUTO
IR receiver unit
2. Press the RESET button.
For the custom code setting of b, c, or d, perform the setting after pressing the RESET button.
•
After completing the procedure above, no address setting signal is received. If the address
setting signal is sent, 5 short beeps will be emitted indicating an error.
• When returning the address setting mode again, press the MANUAL AUTO button for 3 sec-
onds.
1-4. Address setting by remote controller - (07-23) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
