Fujitsu AIRSTAGE J-IIIL - Page 624

 Reconfirmation of address setting
Press and hold the MANUAL AUTO button for 3 seconds.
3 short beeps
MANUAL
AUTO
MANUAL AUTO
IR receiver unit
• Indoor unit address setting
1.
Make sure that the function number is set to “01” with referring the step 2. in "Indoor unit ad-
dress setting" on page 07-19.
2. Press the TIMER set (-) button. Associating indication will be shown on the indoor unit LED
lamps.
Example) ADDRESS: 34
OPERATION lamp
(Green)
TIMER lamp
(Orange)
FILTER lamp
(Red)
0.5 sec ON / 0.5 sec OFF
4 times
3 times 1 to 10 sec
1 to 10 sec
0.5sec ON / 0.5sec OFF
TIMER set (-)
• Refrigerant circuit address setting
1.
Make sure that the function number is set to “01” with referring the step 2. in "Refrigerant
circuit address setting" on page 07-21.
2. Press the TIMER set (-) button. Associating indication will be shown on the indoor unit LED
lamps.
Example) ADDRESS: 25
OPERATION lamp
(Green)
TIMER lamp
(Orange)
FILTER lamp
(Red)
5 times
0
.5sec ON / 0.5sec OFF
1sec ON / 1sec OFF
2 times 1 - 10 sec
1 - 10 sec
0.5sec ON / 0.5sec OFF
TIMER set (-)
1-4. Address setting by remote controller - (07-24) - 1. System settings
FUNCTION SETTINGS FUNCTION SETTINGS