Fujitsu AIRSTAGE UTY-DCGGZ2 - Individual Setting

En-18
2-2-2. IndividualSetting


3
4


 
5
6
7
8
9




No. Item Description

“Group name” / “R.C.G. name”
Selects “Group name” to be set.
For Batch setting, “All Indoor Units” is displayed.

“Special State”
When the currently displayed group or R.C.G. is in a special state, icon is
displayed.
• Displayed states when even one unit is in a special state
Icon State Icon State
Emergency stop Mismatch mode
Maintenance mode Master controlled
Refrigerant leakage Test operation
Error Pump down
Defrost Auxiliary power supply
Oil recovery ― ―
• Displayed state when all units are in a special state
Managed unit (when all indoor units are not master indoor unit, and
master unit is managed or outdoor unit is managed)
3
“Room Temp.” Displays the room temperature.
4
“On/Off” Selects “On” or “Off” for operation state.
5
“Mode”
Selects the mode. (“Auto”, “Cool”, “Dry”, “Fan” and “Heat”. Selectable
mode depends on the indoor unit)
6
“Set Temp.”
Selects the “Set Temp.” with 0.5ºC (1ºF) in units. (except when “Fan” or
“Off” is selected)
7
“Set Temp. (Custom Auto)” “Cool”*
Selects the “Set Temp.” during “Cool” operation and the “Set Temp.”
during “Heat” operation when operation mode is “Custom Auto”. (Applied
indoor unit and non-applied outdoor unit cannot bemixed.)
8
“Set Temp. (Custom Auto)” “Heat”*
9
“Fan Speed”
Sets “Fan Speed”.
“Auto”, “High”, “Med-High”, “Med”, “Med-Low”, “Low”, “Quiet”

“Air Flow Direction”
Sets“AirFlowDirection”.→Refer to 2-2-2-1.

“Anti Freeze” Sets “Anti Freeze” operation. Select “On” or “Off”.

“Economy” Sets “Economy” operation. Select “On” or “Off”.

“Temp. Limit”
Sets“Temp.Limit”.→Refer to 2-2-2-2.

“Filter Sign” Resets “Filter Sign”. (Operation accumulated time is reset.)

“R.C. Prohibition”
Sets“R.C.Prohibition”.→Refer to 2-2-2-3.

“Human Sensor”
Sets“HumanSensor”.→Refer to 2-2-2-4.

Group / R.C.G. switch-over button Switches over between group display and R.C.G. display.
* “Set temp.” is displayed only when a unit with Custom Auto function is registered.
Custom Auto:
Set the set temperature for cooling and the set temperature for heating separately. During the Custom Auto mode
operation, when the room temperature exceeds the set temperature for cooling, the cooling operation is performed, and
when the room temperature falls below the set temperature for heating, the heating operation is performed. (It can be
used only when the setting of the indoor unit compatible with this function is valid.)
Note