Fujitsu AIRSTAGE UTY-DCGGZ2 - Preference; Backlight Setting; Panel Calibration

En-29
3-2. Preference
When the password is set at start-up, enter the password. (Refer to 3-2-5.)
3-2-1. BacklightSetting
Arrange the LCD backlight.
(1) Tap the MENU button.
(2) Tap the [Preference].
(3) Tap the [Backlight Setting].
(4) Set the item and tap the [OK] button.
No. Item Description

“Automatic Off
Time”
Sets the automatic light-off time.
[1 minute to 30 minutes]

“Brightness”
Sets the brightness.
Dark1↔2↔3Bright
3
“Screen lit
while in error
status”
Selects “Enable” or “Disable” of the
setting for emergency light-on.
“Enable” / “Disable”
3-2-2. Panel Calibration
Calibrate the position of LCD panel.
The buttons on the touch panel operate normally by calibration.
Only procedure (4) is displayed at initial setting.
(1) Tap the MENU button.
(2) Tap the [Preference].
(3) Tap the [Panel Calibration].
(4) Tap the center of + marks which appear in turn at 5 places (
to 5).
Re-check Panel Calibration screen is displayed. Touch the 5
places again.
(1)
(3)
(2)


3
(1)
(2)
(3)


5
4 3