Fujitsu AIRSTAGE UTY-DCGGZ2 - Installer Setting; Language Setting; Central Controller Address Setting

En-35
3-4. InstallerSetting
When the password is set at start-up, enter the password. (Refer to 3-2-5.)
3-4-1. LanguageSetting
Select the languages to be used on this controller.
Only procedure (4) is displayed at initial setting.
(1) Tap the MENU button.
(2) Tap the [Installer Setting].
(3) Tap the [Language Setting].
(4) Tap the language.
Language list
English
Español
Deutsch
Français
Italiano
Pycckий
Português
Türkçe
Językpolski
Ελληνικά
Dutch
中文
3-4-2. CentralControllerAddressSetting
Set the address of this controller.
Only procedure (4) is displayed at initial setting.
(1) Tap the MENU button.
(2) Tap the [Installer Setting].
(3) Tap the [Central Controller Address Setting].
(4) Tap the address list “00” – “15”.
When 2 or more controllers* are installed in the system,
set the address numbers so that the controller addresses
(numbers) are not duplicated.
* Touch Panel Controller, Network Convertor(Group Remote
Controller).
Note
(2)
(3)
(4)
(1)
(2)
(3)
(1)