Fujitsu AIRSTAGE UTY-DCGGZ2 - External Input Setting

En-40
3-4-6-2. NetworkSetting
When “Wired LAN” is selected at LAN setting, set the network.
(1) Set the item and tap the [OK] button.
[Initialvalue:Addressesaresetasshownintheleftgure.]
No. Item Description

“IP Address” (*) Sets “IP address” of this controller.

“Subnet Mask”
(*)
Sets “Subnet mask” of this controller.
3
“Default
Gateway” (*)
Sets “Default Gateway” of this
controller.
4
“Primary DNS”
(*)
Inputs “Primary DNS” (Domain Network
Service) of this controller.
5
“Secondary
DNS” (*)
Inputs “Secondary DNS” (Domain
Network Service) of this controller.
(*) [***.***.***.***] (Input 0 to 255 at “***”.)
3-4-6-3. IndoorUnitSensorRoomTemp.DisplaySetting
Display the room temp. to the operating indoor unit even if remote controller or option sensor is not used.
(1) Tap the MENU button.
(2) Tap the [Installer Setting].
(3) Tap the [Indoor unit sensor room temp. display].
(4) Tap the [Enable] or [Disable].
3-4-7. ExternalInputSetting
Perform the external input setting.
(1) Tap the MENU button.
(2) Tap the [Installer Setting].
(3) Tap the [External Input Setting].
(4) Set the item and tap the [OK] button.
No. Item Description

“Operation”
Selects “Operation” for external input.
“Emergency Stop”, “All On/Off”, “Not
Used”

“Input Method”
Selects “Input method”.
“Edge”, “Pulse”


4 5
3
(2)
(3)
(4)
(1)
(2)
(3)
(1)

