Fujitsu AIRSTAGE UTY-DCGGZ2 - Mail Setting

En-41
3-4-8. MailSetting
Setsthemailaddressdestinationwhen“Errornotication”or“Roomtemperaturenotication”issent.
(1) Tap the MENU button.
(2) Tap the [Installer Setting].
(3) Tap the [Mail Setting].
(4) Select the setting function.
No. Item Description

“Mail Setting”
Performs the mail account setting, etc.
→Refer to 3-4-8-1.

“Server
Setting”
Performs the mail server connection
setting.→Refer to 3-4-8-2.
* After the Server Setting is performed, perform the Mail
setting.
3-4-8-1. MailSetting
(1) Set the item and tap the [OK] button.
No. Item Description

“Error
notication”
Sets “Enable” or “Disable” of mail
noticationwhenanerroroccurs.

“Email Address”
Sets the mail address destination
when“Errornotication”or“Room
temperaturenotication”issent.
3
“Transmission
Test ”
Performs “Transmission test” to send
thenoticationmail.
Transmission result display:
“Failed sending mail.”(*1) / “Mail sent.”
4
“Room
temperature
notication”
(“Lower Limit”)
(*2)
Sets the room temperature lower limit
for sending a mail.
“Lower limit”: -15.5ºC
5
“Room
temperature
notication”
(“Upper Limit”)
(*2)
Sets the room temperature upper limit
for sending a mail.
“Upper limit”: 63.5ºC
(*1) If sending mail is failed, the failure reason of sending is
displayed. When a mail server error is displayed in failure
reason message, contact the mail server management
company. For other messages, check the appropriate
settings in this controller.
(*2) Forroomtemperaturenotication,wiredremotecontroller
must be connected to the indoor unit and remote sensor
must be enabled.
For the setting method, refer to the remote controller
manual.
* If the server setting is not correct, mail is not sent. For details,
refer to your mail service.
(2)
(3)
(1)




4
5
3

3