Fujitsu AIRSTAGE UTY-DCGGZ2 - Timer Setting

En-42
3-4-8-2. ServerSetting
(1) Set the item and tap the [OK] button.
No. Item Description

“Sender Email
Address”
Inputs sender mail address.

“Outgoing Email
Server Address”
Inputs outgoing mail server (SMTP).
3
“Port” Inputs port No. of SMTP.
4
“Account Name”
Inputs account name (in most
cases, mail address or the part of
mail address before @) for SMTP
authentication. (Max. 50 characters)
5
“Password”
Inputs the password for SMTP
authentication. (Max. 12 characters)
6
“ S S L”
Selects the encryption type according
to mail service.
“None”: Does not encrypt.
“SMTP over SSL”: Encrypts all from
the beginning and performs SMTP
communication.
“STARTTLS”: Starts SMTP
communicationbycleartextatrst
and encrypts the required part of text
from the middle of communication.
* If the server setting is not correct, mail is not sent. For details,
refer to your mail service.
3-4-9. TimerSetting
Set the timer which stops the operation automatically to prevent you from forgetting to turn off.
(1) Tap the MENU button.
(2) Tap the [Installer Setting].
(3) Tap the [Timer Setting].
(4) Set the item and tap the [OK] button.
No. Item Description

“Auto Off Timer”
Sets “Enable” or “Disable” of the timer.
When “Enable” is selected,  to 5
are enabled.

“Operation Stop
Time”
Sets “Operation Stop Time” in
10-minutes unit. [30-240 min]
3
“Time Range”
Selects “Time Range”.
“Range Spec.” / “Continuous”
4
“Start Time”
Sets “Start time”. When “Range Spec.”
is selected, this item is enabled.
5
“End Time”
Sets “End time”. When “Range Spec.”
is selected, this item is enabled.
6
“Registered
groups”
Sets the groups to be controlled.
→Refer to 2-3-1-1.


3
4
5
6
(2)
(3)
(1)


4 53
6