MODEL SELECTION PROCEDURE2-1.
Selection of indoor units
See 2-2-2.MODEL LINE UP(INDOOR UNIT) and
2-3-1. SELECTION PROCEDURE OF INDOOR UNIT AND
OUTDOOR UNIT
See 2-2-3.MODEL LINE UP(OPTIONAL PARTS)
See 2-2-3.MODEL LINE UP(OPTIONAL PARTS)
See 2-2-3.MODEL LINE UP(OPTIONAL PARTS)
See 2-2-3.MODEL LINE UP(OPTIONAL PARTS)
See 2-2-3.MODEL LINE UP(OPTIONAL PARTS)
See 2-2-1.MODEL LINE UP(OUTDOOR UNIT) and
2-3-1. SELECTION PROCEDURE OF INDOOR UNIT AND
OUTDOOR UNIT
Selection of required optional parts
Grill kit for all Cassette type ●
EV kit for AS ●
E07-14
Selection of controller units
System Controller ●
Touch Panel Controller ●
Group Remote Controller ●
Wired Remote Controller ●
Simple Remote Controller(with operation mode) ●
Simple Remote Controller(without operation ●
mode)
Wireless Remote Controller ●
Selection of adaptor / convertor
Network Convertor ●
Network Convertor for L ●
ON
W
ORKS
®
Signal Amplifier ●
External Switch Controller ●
Selection of branch kit
Outdoor Unit Branch Kit ●
Separation Tube ●
Header ●
END
Selection of other optional parts
Flange (square) ●
Flange (round) ●
Long-Life Filter ●
IR Receiver Unit ●
Remote Sensor Unit ●
Drain Pump Unit ●
Air Outlet Shutter Plate ●
Panel Spacer ●
Wide Panel ●
Insulation Kit for High humidity ●
Fresh air intake kit ●
Selection of outdoor units
- (02 - 01) -
MODEL
SELECTION
MODEL
SELECTION
To Next Page
Loading...
