35
2 Pull the data and the power supply connectors from the desired drive (1).
3 Remove the screws (2) and take the drive out of the system unit (3).
CAUTION
For cooling, protection against fire and in order to comply with EMC regulations, you must refit
the plastic cover.
4 Press the plastic drive cover into the front panel until it snaps in place.
5 Close the system unit (see "Assembling the system unit").
It may be necessary to modify the entry for the drive in the BIOS Setup.
Removing an accessible drive
1 Open the system unit (see "Opening the system unit").
1
3
2
2
CHAPTER 4 Martini2 (27-44) 12/21/01, 10:15 AM35
To Next Page
Loading...
