37
1
1
3
2
1
1 Remove the screws.
2 Take the new floppy disk drive out of its packaging.
3 Replace the floppy disk drive.
4 Fasten the drive with the screws.
1 Slide the drive into the system unit (1).
2 Plug the connectors of the data cable and the power supply cable into the floppy disk
drive (3).
Make sure the polarity is correct.
3 Fasten the drive with the screw (2).
4 Close the system unit (see "Assembling the system unit").
It may be necessary to modify the entry for the drive in the BIOS Setup.
CHAPTER 4 Martini2 (27-44) 12/21/01, 10:15 AM37
To Next Page
Loading...
