Preparation for use
A26361-K1001-Z220-1-7619, Edition 8 11
Installing the software
► During installation, follow the instructions on screen.
► Consult the operating system manual if there is anything unclear about the requested input
data.
i
You will find further information about the system as well as drivers, additional software
and updates on the "Drivers & Utilities" CD/DVD.
External devices, connecting
!
Read the documentation on the external device before connecting it.
With the exception of USB and FireWire devices, always remove all power plugs before
connecting external devices!
Do not connect or disconnect cables during a thunderstorm.
Always take hold of the actual plug. Never unplug a cable by pulling the cable itself.
Connect and disconnect the cables in the order described below.
Connecting cables
● Switch off all equipment concerned.
● Remove all the mains plugs for the equipment concerned from the mains sockets.
● Plug in the cables at the device and peripheral equipment. Always pay careful attention to the
safety information provided in the "
Important notes" chapter and in the "Safety" manual.
● Plug the data communication cables into the data/telephone network sockets.
● Insert the mains plugs into earth-protected mains sockets.
Disconnecting cables
● Switch off all equipment concerned.
● Remove all the mains plugs for the equipment concerned from the mains sockets.
● Unplug the data communication connectors from the data/telephone network sockets.
● Unplug all cables from the device and peripheral equipment.
i
USB and FireWire devices are hot-pluggable. This means you can connect and disconnect
devices while your operating system is running.
Additional information can be found in the "
Connecting external devices to the USB ports"
section and in the documentation for the USB devices.
To Next Page
Loading...
